After making an LED Christmas tree, I felt I really had to make an LED Advent Wreath!
I had a circular PCB by chance (as I tend to grab everything I can get my hands on when being recycled!):
Image may be NSFW.
Clik here to view.
I needed something to be the ‘candles’. Initially was thinking to go with putting the LEDs on the top of real candles to simulate the flame. But most likely I’d be storing this with the Christmas stuff in the attic after Epiphany and due to the Texas heat we typically don’t store candles there.
So after wandering around the store, thinking that I needed ‘magical colored plastic tubes’, I stumbled on these:
Image may be NSFW.
Clik here to view.
These perfectly fit on some white LEDs I had. I chose the most purpley and pink ones in the batch and cut them in half.
Next, in order to save myself replacing batteries and to keep the Advent Wreath lit as much as possible, I went and recycled a 5V Power Supply cable I had from an old bluetooth headset. (Electronics may die but power supplies live forever!).
Hooking up LEDs is generally very simple, you have to choose the proper resistor in series with them to limit the current through them. Wasn’t sure exactly on mine, but generally white LEDs have a forward voltage of 3.6V and can handle up to 20mA. I went with 100Ω per on online LED calculator (and because 100Ω is the smallest I have!).
Image may be NSFW.
Clik here to view.
Hookeing everything up to the ring PCB, it looks like this:
Clik here to view.
5V power supply hookup
Added a way to ‘light’ and ‘blow out’ the candles using some jumpers:
Clik here to view.
One “candle”. Jumpers added to permit “lighting” the candle.
Clik here to view.
Almost done!
Clik here to view.
Lights on!
Clik here to view.
Straws attached
Found some old plastic wreath material:
Image may be NSFW.
Clik here to view.
Glue gun was already on the table! (Wife making a Christmas wreath):
Image may be NSFW.
Clik here to view.
Now I can keep this Advent Wreath lit much longer than usual! Happy Advent y’all!